xiehe model

Do you know the conditions of use of CNC lathes? Next, the editor of Xiehe CNC processing factory will give you a brief introduction.

The normal use of CNC lathes must meet the following conditions. The power supply voltage fluctuation at the location of the machine tool is small, the ambient temperature is lower than 30 degrees Celsius, and the relative temperature is lower than 80%.

1. Environmental requirements for the location of the machine tool

The position of the CNC machine tool should be far away from the vibration source, avoiding the influence of direct light and heat amplitude, and avoiding the influence of moisture and air flow. If there is a vibration source near the machine tool, anti-vibration ditch should be set around the machine tool. Otherwise, it will directly affect the machining accuracy and stability of the machine tool, and will cause poor contact and failure of electronic components, which will affect the reliability of the machine tool.

2. Power requirements

Generally, CNC lathes are installed in machining workshops, not only the ambient temperature changes greatly, the use conditions are poor, but also there are many kinds of electromechanical equipment, resulting in large fluctuations in the power grid. Therefore, the location of CNC lathes requires strict control of the power supply voltage. The fluctuation of the power supply voltage must be within the allowable range. within, and remain relatively stable, otherwise it will affect the normal work of the CNC system.

3. Temperature conditions

The ambient temperature of the CNC lathe is lower than 30 degrees Celsius, and the relative temperature is lower than 80%. Generally speaking, there is an exhaust fan or cooling fan inside the CNC electric control box to keep the electronic components, especially the central processing unit, at a constant temperature or with little change in temperature difference. Excessive temperature and humidity will reduce the life of control system components and lead to more failures. The increase of temperature and humidity, and the increase of dust will cause bonding on the integrated circuit board and cause short circuit.

4. Use the machine tool according to the regulations in the manual

When using CNC machine tools, users are not allowed to change the parameters set by the manufacturer in the control system at will. The setting of these parameters is directly related to the dynamic characteristics of each component of the machine tool. Only the gap compensation parameter value can be adjusted according to the actual situation.

The user cannot replace the machine tool accessories at will, such as using a hydraulic chuck that exceeds the specifications specified in the manual. When setting up accessories, the manufacturer fully considers the matching of parameters in various links. Blind replacement results in a mismatch of parameters in various links, and even unexpected accidents.

The above content is the use conditions of CNC lathe processing, I hope it can be helpful to everyone.