xiehe model

The possibility of host computer failure in most electric vehicles is often caused by various reasons. Below, the editor will give you a brief introduction to the application of impeller processing in host computers in electric vehicles.

Application of impeller processing in upper computer of electric vehicles:

Due to the mechanical stroke management of the electric vehicle host computer, poor action control of the drive motor, or loose fasteners, etc. Improper action control setting of the drive motor not only increases the control current, but also brings a lot of trouble to the driving operation of the electric vehicle. There is no nut installed on the lower edge of the spindle as a reversing leg. There are no nuts on the front and rear edges of the spindle, and the suction force at the top of the spindle is small, making the equipment difficult to install and causing severe installation deformation. After replacing the main shaft, strengthening the manufacturing and protection of the components can not only prevent secondary sliding, but also further reduce the deformation of the main bearing shaft diameter. All nuts and fasteners were replaced at the end of the repair. The ZG impeller developed by our employees can solve this problem very well.

The ZG impeller adopts hydraulic technology and uses a special chain belt for tooling, but its tooling fixed point can be determined as the front end of the hydraulic speed control rod. The hydraulic speed control rod is the ground wire, responsible for adjusting the speed control table and hydraulic transmission system. Reduces external speed lever damage, equipment repairs or costs.