xiehe model

When everyone uses the CNC processing factory for long-term processing, they will suddenly find that the CNC processing factory has random cutting phenomena, but everyone does not know how to deal with the random cutting phenomenon in the CNC processing factory. Therefore, Xiehe Processing Factory will briefly introduce to you the solution to the problem of random cutting in CNC processing plants.

1. This situation may be caused by a problem with the upper and lower processing ports of the machining center. The operator will use the resetting button to change the calculation method, or simply press the emergency stop button.

2. At the same time, a typical machining center PLC program (PLC programming is an electronic system for digital operation, designed for use in an industrial environment) refreshes the tool list after completing changes. Your procedure should be something like this, but after you have a problem with the cover, you just put the knife down and after repairing it, I think it should be fine on the original knife rest and have a messed up knife.

3. Communicate with the manufacturer you purchased from. Assuming the manufacturer has after-sales service or after-sales maintenance, you can ask their technicians to check the safety. In addition, after the tools are out of order, remember not to operate the operation panel keyboard of the machining center. If you don't know PLC, please try using external force to help the tool holder complete the movement. Be sure to pay attention to safety during operation. Check to have the machining center tool library complete the entire M6 cycle on its own, so it's guaranteed to be mess-free.

4. During normal tool changing, the tool changing process is stuck due to insufficient tool changing air pressure. After the manual tool magazine is reset (reset), tool magazine chaos may occur.

5. When the machining center manipulator changes tools, the operator presses the RESET key or emergency stop key. As a result, the tool change stops unexpectedly, which may lead to random tool changes in the tool magazine.

6. Due to damage to the mechanical structure of the machine tool, perhaps the parameters of the CNC system are lost, or chaotic errors lead to the phenomenon of random cutting.

The above content is the solution to the phenomenon of random cutting in CNC processing factories. I hope it can be helpful to everyone. If you want to know more relevant information, please call Xiehe Processing Factory, we will serve you wholeheartedly.