xiehe model

Everyone knows that in the cnc processing factory, we have many things to pay attention to during the cnc processing process. However, many people are not very clear about the things that need to be paid attention to in the cnc processing process. Therefore, the Xiehe cnc processing manufacturer will briefly introduce to you what we need to pay attention to in the cnc processing process.

1. Before each program is processed, it is necessary to strictly confirm whether the tool on the program is consistent with the program;

2. When installing the knife, you must confirm the length of the knife and whether the selected clamping head is suitable;

3. Stop opening the door during machine tool operations to avoid flying knives or workpieces;

4. If a knife collision is found during processing, the operator must stop immediately, such as pressing the "emergency stop" button or the "reset button" button or adjusting the "feed rate" to zero, etc.;

5. In the same workpiece, the tool must be kept in the same area every time, so as to ensure the accuracy of the tool when it is connected to the tool. CNC machining center operating rules;

6. If it is found that the machining allowance is too much during the processing, it is necessary to use "single block" or "pause" to clear the X, Y, and Z values to zero, then manually mill them off, and then shake them back to "zero point" to let them work on your own;

7. The operator of the CNC machining center manufacturer is not allowed to leave the machine tool or regularly check the operation status of the machine tool during its own operation. If it is necessary to leave halfway, it is necessary to designate relevant personnel to check;

8. Before the light knife oil injection, the aluminum slag in the machine tool must be cleaned to prevent the aluminum slag from absorbing oil;

9. Try to use air blowing in the roughing program, and spray oil in the light knife program

10. After the workpiece is off the machine, it must be cleaned and deburred in time;

11. When off duty, the operator must make timely and accurate explanations to ensure that subsequent processing can proceed normally;

12. Before shutting down, ensure that the tool magazine is in the original position, the XYZ axes are in the middle position, and turn off the power supply and the main power supply on the machine tool operation panel in sequence;

13. In case of a thunderstorm, the power supply must be cut off immediately to interrupt work.

The above thirteen points are the things that need to be paid attention to in the cnc processing process that the Xiehe cnc processing manufacturer briefly explained to you. I hope it will be helpful to you. If you want to know more about the CNC processing factory, please call Xiehe CNC processing factory, we will serve you wholeheartedly.