xiehe model

Do you know the unexpected solution in the process of prototype processing? Next, the Xiehe prototype processing factory will give you a brief introduction.

There are always certain risks in any work, and there are also certain accidents in the process of hand model processing.

During the prototyping process, because the material properties are very brittle and easy to crack, and there can be no bonding marks, special attention should be paid during the processing. Once the knife is cut too fast, the entire material may break, and the entire prototyping will be scrapped. Therefore, the PMMA prototyping Samples are also more expensive than other prototypes. If there is a mistake, the method we give is as follows:

There are some large mistakes in the prototype model that cannot be remedied and can only be scrapped, such as transparent parts PMMA, PC, etc., because transparent parts are not allowed to have bonding traces, but some parts can be remedied to recover losses. Non-transparent parts, such as ABS, POM, PA, etc., are generally remedied for plastic parts. The remedial method can generally use remedial materials to fill in the over-cut or mis-cut places. The commonly used remedial materials are 502 glue mixed with prickly heat powder or putty. Take an appropriate amount of prickly heat powder and add 502 glue to make a thin paste to become 502 glue mixed prickly heat powder. Fill the adjusted material into the overcut area and wait for it to dry before reprocessing.

The above content is the solution to the unexpected occurrence in the process of prototype processing, and I hope it can be helpful to everyone. If you want to know more about hand processing, please call Xiehe hand processing factory, we will serve you wholeheartedly.