xiehe model

Do you know what the conditions for using CNC lathes are? Next, the editor of Xiehe Processing Factory will give you a brief introduction.

The normal use of CNC lathes must meet the following conditions: the power supply voltage at the location of the machine tool has small fluctuations, the ambient temperature is lower than 30 degrees Celsius, and the relative temperature is less than 80%.

1. Machine tool location and environmental requirements

The location of CNC machine tools should be far away from the vibration source, avoid the influence of direct light exposure and heat amplitude, and avoid the influence of moisture and air flow. If there is a vibration source near the machine tool, anti-vibration trenches should be set up around the machine tool. Otherwise, it will directly affect the processing accuracy and stability of the machine tool, cause poor contact of electronic components, cause malfunctions, and affect the reliability of the machine tool.

2. Power requirements

Generally, CNC lathes are installed in machining workshops. Not only do the ambient temperatures change greatly and the usage conditions are poor, but there are also many kinds of electromechanical equipment, resulting in large fluctuations in the power grid. Therefore, the location of the CNC lathe requires strict control of the power supply voltage. The power supply voltage fluctuation must be within the allowable range. within and remain relatively stable, otherwise it will affect the normal operation of the CNC system.

3. Temperature conditions

The ambient temperature of the CNC lathe is lower than 30 degrees Celsius, and the relative temperature is less than 80%. Generally speaking, there is an exhaust fan or air cooler inside the CNC electric control box to keep the operating temperature of electronic components, especially the central processor, constant or the temperature difference changes very little. Excessive temperature and humidity will reduce the life of control system components and lead to increased failures. The increase in temperature and humidity and the increase in dust will cause adhesion on the integrated circuit board and lead to short circuits.

4. Use the machine tool according to the instructions.

When using CNC machine tools, users are not allowed to arbitrarily change the parameters set by the manufacturer in the control system. The settings of these parameters are directly related to the dynamic characteristics of each component of the machine tool. Only the gap compensation parameter value can be adjusted according to the actual situation.

Users cannot replace machine tool accessories at will, such as using a hydraulic chuck that exceeds the specifications in the manual. When setting accessories, the manufacturer fully considers the matching of parameters in each link. Blind replacement causes mismatch of parameters in various links, and even causes unexpected accidents.

The above content is the conditions for use of CNC lathe processing. I hope it can be helpful to everyone. If you want to know more about the CNC processing factory, we will serve you wholeheartedly.